MDB Green Climber LV800

Questions and Answers

H
hallandrewAug 18, 2025
How to troubleshoot if MDB Construction Equipment does not start?
- W
  williamjacksonAug 18, 2025
  If your MDB Construction Equipment doesn't start, first ensure the emergency button is not pressed; if it is, disengage it. Next, check that the battery contact key is properly inserted and connected. Also, verify that the fuel tank is filled. Lastly, inspect the fuse and replace it if damaged.
A
Angela SweeneyAug 21, 2025
What to do if the engine of my MDB Green Climber LV800 turns off?
- S
  savannah54Aug 21, 2025
  If the engine of your MDB Construction Equipment turns off, check these items: First, disengage the emergency button if it's pressed. Second, ensure the fuel tank is full. Third, the issue might be a lack of radio signal, in which case you should connect the transmitter and receiver. If none of these steps work, there may be a faulty electro-stop, and you should contact the dealer.
E
Elizabeth RobinsonAug 23, 2025
Why is the radio remote control not working on my MDB Green Climber LV800 Construction Equipment?
- N
  Nicole JonesAug 23, 2025
  If the radio remote control for your MDB Construction Equipment is not working, try these steps: First, recharge the battery. Second, ensure the transmitter and receiver are correctly connected. Third, check that the emergency button is not pressed. Finally, confirm that the transmitter has the same serial number as the receiver.
C
Christopher GillespieAug 26, 2025
What to do if MDB Green Climber LV800 engine starts but the machine does not move?
- M
  Michael RiveraAug 26, 2025
  If the engine of your MDB Construction Equipment starts but the machine won't move, try moving backward and forward repeatedly to unlock the brakes, especially if the hydraulic oil is cold. Also, make sure the speed potentiometer on the remote control is not set to zero; turn it to the desired speed. If the problem persists, it may be a pump or motor issue, and you should contact the dealer.
E
Eric MckinneyAug 28, 2025
Why is the battery LED off on my MDB Green Climber LV800 Construction Equipment remote control?
- T
  Tristan RogersAug 28, 2025
  If the battery LED is off on your MDB Construction Equipment remote control, verify if the fuse is blown and replace the receiver fuse. Also, check if the battery is flat and recharge it if necessary.
L
Linda SotoAug 30, 2025
What causes MDB Green Climber LV800 Construction Equipment to not go straight when the engine starts?
- A
  antonio16Aug 30, 2025
  If your MDB Construction Equipment starts but doesn't move straight, try turning the steering potentiometer to the center position. If that doesn't resolve the issue, it could be due to a dirty or ruined pump solenoid valve, damaged hydraulic pump or motor, or a blown RC fuse, and you should contact the dealer.
C
Cheryl Foster DDSSep 1, 2025
What does it mean if the RF busy LED is flashing or off on my MDB Green Climber LV800 Construction Equipment remote control?
- N
  navarrolaurenSep 1, 2025
  If the RF busy LED is flashing or off on your MDB Construction Equipment remote control, check the aerial connection to ensure there is a radio signal. If there is interference from another radio signal, use only one machine at a time or use the emergency electrical cable.
K
Kimberly PughSep 3, 2025
What to do if MDB Construction Equipment engine starts but the machine doesn't move and the warning light is off?
- M
  Micheal TaylorSep 3, 2025
  If the engine starts, but the MDB Construction Equipment does not move and the warning light on the transmitter is off, connect the transmitter and receiver.
S
Sandra KingSep 6, 2025
Why am I getting an intermittent signal while moving my MDB Green Climber LV800?
- S
  Shelly WaltonSep 6, 2025
  If you experience an intermittent signal while moving your MDB Construction Equipment, first, fill the tank, as the fuel may be running out. If the issue persists, it may be an alternator problem or expired routine maintenance, in which case you should contact the dealer or carry out maintenance as indicated by the operations and maintenance manual.
A
Alexander HernandezSep 8, 2025
What to do if the tracks on my MDB Green Climber LV800 Construction Equipment are loose?
- J
  James ReedSep 8, 2025
  If the tracks on your MDB Construction Equipment are loose, tighten them. If the rubber is worn or there is a track tension system failure, contact the dealer.