SPECIFICATIONS
Dimensions 1.45 x 0.55 x 2.44 inches
(3.7 x 1.4 x 6.2 cm)
Weight 2 oz. (56 grams)
Sensor Technology Advanced Semiconductor
Detection Range 0.00 - 0.40 %BAC
Power Supply Two AAA Alkaline Batteries - not included
Battery Life 100 - 150 tests
Warm Up Time 11 - 13 seconds
Response Time 5 seconds
Operating
Temperature
50 - 104 degrees Fahrenheit
(10 - 40 Celsius)
Display shows ‘FL’
The FL notication can appear in three cases:
• The user did not blow continuously for
ve seconds.
• The user may still have alcohol in
their saliva, and the measured alcohol
concentration is uneven. Users should wait
20 minutes after their last drink to make
sure alcohol in the mouth is fully absorbed
and a proper breath sample can be taken.
• The user may have blown too hard.
Try again with a more moderate and
consistent blow.
Display shows ‘H’
Reading exceeds upper limit of .40% BAC.
Make sure user has waited 20 minutes after
consuming alcohol before blowing.
Display shows ‘Er’
The sensor is damaged. Contact support
for assistance.
11
12
Error Notifications
DISPLAYS
Display shows ‘Lo’
When low battery icon appears, replace with
new AAA Alkaline batteries.
Display shows ‘0.00’
If an attempt at the breath sample is detected,
but not completed, the unit will display .00
and then power off.
To Next Page
Loading...