I
MDR-2000 VJ User's Reference Manual
Interactive Monitor
5.2.2
Show
Command
Details
The
SHOW
command provides for a number
of
options each specifying different information to be
displayed. This section deals with each
of
these options and the way they are implemented by the
Interactive Monitor.
The following paragraphs deal with each
of
the SHOW command options.
SHOW ALARM -
Displays the contents
of
the Alarm Table. The entries
of
the Alarm Table
which is setup by the ALARM TABLE command are output one per line on the
user's
display.
Note that empty entries will not be displayed. Also, since no scrolling is provided the display may
run
off
the top
of
the screen.
In
this case using a terminal emulation program to capture the table is
a suitable alternative.
SHOW AUTODIAL -
Lists information used by the autodialer including retry thresholds and the
user programmable telephone numbers. The retry thresholds are for information purposes only,
there are no commands to alter these settings. The telephone numbers can be modified by using the
SET PRIMARY PHONE and SET SECONDARY PHONE commands.
SHOW DIGITS -
Displays the contents
of
the Digits Table. The entries
of
the Digits Table which
is setup by the DIGITS TABLE command are output one per line on the user's display. Note that
empty entries will not be displayed. Also, since no scrolling is provided the display may run
off
the
top
of
the screen.
In
this case using a terminal emulation program to capture the table is a suitable
alternative.
SHOW
HELP
-
Provides a list
of
the
SHOW
command keywords to be displayed.
SHOW IDENT -
Displays data identifying the MDR-2000 software including
PBX
generic
supported, software revision, serial number, copyright notice, site number and site name. This
command is an expanded version
of
the AVID command. The site number and site name are blank
by default. These values can be set by using the SET SITE and SET
NAME
commands
respectively.
SHOW MAINT -
Displays maintenance data for diagnostic purposes. It is identical to the AVSM
command except that no transmission protocol is used. Each
of
the fields is described in section
6.2 'Remote Examination'.
SHOW
PORT
-
Displays the RS-232, Transfer Blocksize and Descrete Mode settings.
On
the first
line the PBX port is output first followed by the
modem
port settings. The settings are output as
5-15
To Next Page
Loading...