Page 4 Version 4
Step 8 – Adjust the machines elevation by loosening the ¾” nut on the side of
the machine. Tip machine backwards to the desired angle and then retighten the
nut securely.
Step 9 – Adjust the machines tilt by loosening the ¾” nut on the front and rear on
the base of the machine, as shown below. Tilt the machine to the desired angle
and then retighten both nuts securely.
Step 10 - Carefully load carousel with clays, removing any clays that show signs
of damage. Load clays as evenly as possible and do not over load.
Step 11 – Your machine is now loaded and ready to fire. Make sure that the
machine is pointed in a safe direction.
Step 12 – Standing at arm’s length behind the machine, press the
ARM/OFF/DISARM toggle switch to ARM. The machine will load a clay and
come to the armed position and is now ready to fire and must be treated with
extreme caution.
To Next Page
Loading...
