1. Prepare the door and check dimensions
2. Install the latch and strike
3. Install exterior assembly
Parts List
Latch
Strike Strike box
Front Body
Mounting Plate
Back Body
Battery Cover Latch and Strike Screws
4. Install interior assembly
IMPORTANT: Do not load batteries until lock is completely installed.
Remove the battery
cover.
Connect the cable and ensure
tight cable connection.
Rotate the turnpiece in vertical position
and install the interior assembly.
Test the turnpiece for smooth rotation. If turnpiece doesn’t rotate,
repeat step 4C, making sure the turnpiece in vertical position.
Secure the interior assembly
with the supplied screws.
Measure to confirm that the hole in door is
2-1/8" (54mm).
2-1/8"
2/5"
Measure to confirm that the backset is
either 2-3/8" or 2-3/4" (60mm or 70mm).
Measure to confirm that the hole in door
edge is 1
" (25mm).
Measure to confirm that the door is
1-3/8" to 2" (35mm to 50mm) thick.
1"
1-3/8" to 2"
Backset
2-3/8" or 2-3/4"
60 or 70 mm
Hold the latch in front of the door hole, with the latch face
flush against the door edge.
A
Use a screwdriver to test if
deadbolt works smoothy.
C
Slotted hole is centered.
Slotted hole is NOT
centered.
YES
NO
Is the slotted hole centered in the door hole?
No adjustment is required.
Proceed to next step.
Rotate and pull the latch
as shown to extend latch.
1
70mm
2
Is the door edge chiseled?
B
Install strike on the door frame.
D
IMPORTANT: Before installation, make sure the
latch is fully retracted (in the unlocked position).
Route the cable below the latch.
A
IMPORTANT: Make
sure hole in door frame
is drilled a minimum of
1" (25mm) deep.
B
unlocked
Secure the mounting plate
with the supplied screws.
Send the cable through the bottom horizontal
slot in the mounting plate.
C D
Insert the
torque blade
through the
slot in the
latch.
A B C
D E
While the door is OPEN and UNLOCK,
load 4 AA batteries into the interior assembly.
IMPORTANT: For best results, use new,
non-rechargeable Alkaline batteries only.
Press and hold the Reset button on the
interior assembly using the reset tool.
5. Detect left/ right hand door installation
Reset the lock to teach the lock the orientation of the door.
IMPORTANT: This step is required and crucial for the lock to operate properly.
A B
A B
C D
54mm
25mm
35mm to 50mm
10mm
unlocked
Installation Guide
Mechanical Key
Front Body
Latch
Mounting
Plate
Back Body
Battery
Cover
Mounting Plate
Screws
Strike
Interior Assembly Screws
Latch/Strike Screws
Latch/Strike Screws
Strike Box
Screw
Connecting
Point
Connecting Point Mechanical KeyMounting Plate Screws
Interior Assembly
Screws
unlocked
M20
Smart Lock
Installation and
Operation Manual
To Next Page
General