MECNOSUD MX Series - Page 35

Chapter 4 35
ENGLISH
CHAPTER 4 OPERATION
Before beginning each cycle of work, ascertain that the machine is perfectly clean in particular
the surfaces of contact of the bowl, spiral and central guard, which must be treated with detergents
compatible with alimentary products. Whenever necessary, proceed to cleaning according to
procedure 5.1.
4.1 Operation of the 3 speed with selector model machine
(Series MX...T)
1 . POSITION THE GENERAL SWITCH A TO 1
2 . SET THE TIMER B TO MAUAL OR AUTOMATIC ACCORDING TO THE DESIRED
TYPE OF OPERATION
3 . ENGAGE THE START BUTTON E
4 . SET-UP THE OPERATING SPEED (1, 2 or 3) BY OPERATING THE SPEED CHANGER C
5 . IN THE CASE OF THE PROTECTION GRILL OPENING, THE MACHINE STOPS.
TO RESTART IT, CLOSE THE GRILL AND PRESS THE START BUTTON E AGAIN
6 . TO STOP THE MACHINE, PRESS THE STOP/EMERGENCY BUTTON F
OR WAIT UNTIL THE END OF THE WORK CYCLE SET BY TIMER B
4.2 Operation of the machine model with continuous change
with manual command (Series MX...P)
1 . POSITION THE GENERAL SWITCH A TO 1
2 . SET THE TIMER B TO MAUAL OR AUTOMATIC ACCORDING TO THE DESIRED
TYPE OF OPERATION
3 . PRESS THE START BUTTON E
4 . OPERATING THE DIAL C DEFINES THE SPEED, FROM 30 TO 120 TURNS/MINUTE
5 . IN THE CASE OF THE PROTECTION GRILL OPENING, THE MACHINE STOPS.
TO RESTART, IT CLOSE THE GRILL AND PRESS THE START BUTTON E AGAIN
6 . TO STOP THE MACHINE, PRESS THE STOP/EMERGENCY BUTTON F
OR WAIT UNTIL THE END OF THE WORK CYCLE SET BY TIMER B