MEDC DB3 - Certification and Approvals; IECEx Unit Certifications; ATEX Unit Certifications

© Cooper M E DC 2013
E-Mail: info@medc.co.uk
Title:
PROCEDURE/
Fax: +44 (0)1773 580282
DOCUMENT NO.
Tel: +44 (0)1773 812249
DB3 TECHNICAL MANUAL
DD036-06-03
Colliery Road, Pinxton, Notts., NG16 6JF U.K.
REV`D
MEDC
5.0 CERTIFICATION/APPROVALS
IECEx units
Certified to IEC 60079-0, IEC 60079-1 and IEC 60079-7
Ex d IIC unit (IEC certification No. IECEx BAS 11.0083X)
Ex d IIC T
G
(T
amb.
) Gb
Ex tb IIIC T
D
(T
amb.
) Db IP66
Ex de IIC unit (IEC certification No. IECEx BAS 11.0084X)
Ex de IIC T
G
(T
amb.
) Gb
Ex tb IIIC T
D
(T
amb.
) Db IP66
The IECEx certificate and product label carry the IECEx equipment protection level marking
Gb
Db
Where Gb signifies suitability for use in a Zone 1 surface industries area in the presence of gas.
Where Db signifies suitability for use in a Zone 1 surface industries area in the presence of dust.
ATEX units
Certified to EN50014:1997, EN50018:1994, EN50019:1994 & EN50281-1-1:1998
EExd IIC Atex Certifictaion Number BAS 00ATEX2097X
EExde IIC Atex Certification Number BAS 00ATEX2098X
See special conditions for safe use for ambient temperature ranges and T-ratings
The ATEX certificate and product label carry the ATEX group and category marking:
II 2 GD
Where:
Signifies compliance with ATEX
II Signifies suitability for use in surface industries
2 Signifies suitability for use in a zone 1 area
G Signifies suitability for use in the presence of gases
D Signifies suitability for use in the presence of dust
The ATEX certificate and product label also carry the following mark:
This signifies unit compliance to the relevant European directives, in this case 94/9/EC, along with the number
of the notified body issuing the EC type examination certificate.