What to do if my Medema Wheelchair MC 1124 will not run and there is no light in the battery indicator?
First, ensure that the MC 1124 is turned on using the I/O button. If it still doesn't run, the batteries may be discharged, so charge them for at least 12 hours. Also, check if the thermal protection has popped out and press it back in. Finally, turn off the charger and remove the charging socket.
Why is my Medema MC 1124 driving speed too low?
Several factors can cause low driving speed: insufficient air in the tires (pump to 3.5 bar), overloading the wheelchair, the seat being raised too high, or low battery capacity. Stop and wait a few minutes before starting again. Lower the seat and recharge or replace the batteries to resolve this.
What to do if my Medema Wheelchair MC 1124 will not run, but there is light in the battery indicator?
If the MC 1124 doesn't run but the battery indicator is lit, a function key for a function that is not mounted may have been pressed. Try pressing the function key that is lit and turn the device off using the I/O button. Wait 5 seconds, then press the I/O button again.
Why does my Medema Wheelchair have too few km per charging?
This can happen because the batteries are not working correctly, there isn't enough air in the tires, or the charging method is wrong. Recharge your batteries, and ensure the green light on the charger illuminates. Pump pneumatic wheels to 2,4 bar. Consult the manual for proper charging procedures.
What to do if the charging lamp is not lit when the charger is connected to an outlet for my Medema MC 1124 Wheelchair?
First, check if there is power at the outlet by turning on the switch. Please read the supplied user manual for the charger.
What does it mean if the status light flashes with 1 flash per cycle on my Medema MC 1124?
A single flash per cycle on the status light indicates that the batteries need charging. Start charging the wheelchair.
What to do if the ready lamp on the charger does not light up even though the charger has been on for 12 hours for my Medema MC 1124 Wheelchair?
This issue might occur due to a power cut. Reconnect the charger and repeat the charging process, then check again after half an hour. Also, ensure that you push the charging plug all the way in and repeat the charging process.
What does it mean if status light flashes with 9 flashes per cycle on Medema MC 1124?
If the status light flashes nine times per cycle, it means the MC 1124 is disengaged when it starts. Switch off the chair and activate the parking brake.
General| Brand | Medema |
|---|---|
| Model | MC 1124 |
| Category | Wheelchair |
| Language | English |
To Next Page