10
appliance in your hand and pull the plastic
container downwards. Make sure that the
silicone O-ring is attached to the reservoir.
Align the container with the guide markers and
slide upwards until it is seated firmly in place.
(See Fig. 3)
CLEANING & MAINTENANCE
Never immerse the appliance in water.
Handwash only. Clean the appliance before
using for the first time. Wash the container and
tips in warm, soapy water and rinse with clean
water. Always switch off the HydroBlast Pro after
each use. Discard any remaining liquid. Clean
the water container in warm, soapy water and
rinse with clean water. The reservoir should be
cleaned once a week. The tips should be cleaned
regularly and replaced when worn.
OPERATING INSTRUCTIONS
To fill:
Ensure that the reservoir is attached properly.
Open the top flap of the appliance. Fill with fresh
water. Make sure that that the silicone O-ring is
fixed properly in place on the flap. Close the flap
after filling (See Fig. 4)
Advisory: for even better results and ultimate
freshness we recommend using mouthwash.
Use:
Select the most suitable tip.
• Tip for standard water pressure
(blue mark)
• Tip for high water pressure (red mark)
• Brush attachment
Insert the tip into the appliance. (See Fig. 5)
Place the tip on your gum between two teeth.
Close your lips gently over the tip until it has
reached the correct position to avoid any
splashing. Lean over a washbasin and set the
appliance to the LO (low) setting. Allow the water
to flow from the mouth into the washbasin.
To Next Page
Loading...
Need help?
General