You will need an Internet
connection and either:
- IOS 9.0 or above
- Android 5.0 or above
IMPORTANT:
1 Contents 3 Fit your Device 4 Create your Account
Before starting your scan it is necessary to create a
Medibio account. To create your secure, private account,
please perform the following steps:
• Open the Medibio ZBLE app.
• Enter your 9-digit Program Code.
• Enter your email address and password to create your
private account and login credentials (this maybe your
personal or work email).
• Confirm your password, if you have not previously
created an account.
• You should receive a verification message that you have
successfully created your account and are now ready
to perform an overnight scan. We recommend you to
complete a test scan for a few minutes. You will receive an
‘test scan complete’ notice after you upload your scan.
• If you do not receive this notice after 10 minutes, please
contact Medibio.
2 Install the App
Install the Medibio app on your iOS or
Android device. To install the Medibio
app, please follow these steps:
• Make sure you have updated your
operating system to iOS 9.0 or
Android 5.1or later.
• Make sure you have a WIFI internet
connection or enable Mobile Data
on your iOS or Android Device.
• Open the App Store app or the
Google Play store and
search for ‘Medibio ZBLE’.
• S elect ‘install’ to install the app on
your iOS or Android device.
• The Medibio app should install
and appear on your iOS or Android
Device.
App Store
Follow the steps below in order to fit your device properly.
• Fit the electrodes onto the connector being careful not to peel
off the paper backing.
• Peel the paper backing off the electrodes and place the Zephyr
Device in the center of your torso as illustrated below:
Zephyr device with electrode connector
Electrode Electrode
IMPORTANT:
Ensure the Zephyr Device is fitted
right way up with “Zephyr” text
facing up.
Zephyr
Zephyr
Please make sure you have all the following
contents in your kit:
• HxM2 wearable device with electrode connector.
• Small packet containing 2 electrodes.
• Large resealable packet containing 6 electrodes.
• Extra battery for Zephyr Device.
• Sticker to mask green light if desired.
• Quick start guide.
5 Running a Scan
Follow the prompts on the Medibio App for starting
and completing a scan. Here are a few important things
to remember when starting your scan:
• Ensure your phone or tablet is fully charged
and/or plug in overnight to a nearby charger
within Bluetooth range.
• Check the battery in your Zephyr device has
greater then 50% charge. (The Medibio app
displays this information when the device is
connected to your phone).
• Complete a scan for 20 - 22 hours. Ensure
you begin your scan 2 hours before sleep
• We recommend beginning a scan at noon
100%
Medibio
ZBLE App
Google Play
To Next Page
Need help?
General