MEDICRYSTAL MATS
TM
SETUP FOR OPERATION
These are some important steps to start your
MediCrystal Mat
TM
properly.
If your area is subject to frequent electrical blackouts
or power spikes, it could be better to connect the device to
electricity through a surge protection device. It will protect the
controller from power surge caused faults. No urgent problem
if you have not one in hands, you can start your mat without
it, it’s just a precaution to protect your investment. Please, get
a surge protector as soon as it is convenient.
If you have any kind of medical issue or disease, it is
strongly recommended NOT TO USE the mat without the
Health Professional approval. This mat should not to be used
by infants, pregnant women, patients with organ transplants
or incapacitated persons. Do not use on heat sensitive skin,
face, genitals or where there is loss of feeling. Do not use
heat topicals with mat, skin burns may occur. If you have
pacemakers and implants of any kind, ask your doctor if Far
InfraRed (FIR) heat is safe for you. To ensure your safety with
the mat, please, study Contraindications, Precautions, Safety
Instructions and Usage Tips sections of this owner’s guide and
most important - CONSULT A DOCTOR before using thermal
therapy particularly on mid-range and high-level temperatures.*
Please, email to support@MediCrystal.com the device
model and serial number (should be on your mat or controller
sticker) for automatic warranty activation. You can also register
your products at our website MediCrystal.com in the bottom
right end «newsletter» link.
MEDICRYSTAL MAT
TM
CONTROLLER
MEDICRYSTAL MAT
TM
CARRY
AND STORAGE BAG
WATERPOOF CASE WITH
MULTILAYER MEMBRANE AND
BUILT-IN 3D PAD FOR COMFORT
BODY SUPPORT AND MEDICRYSTAL
MAT
TM
PROTECTION
USER MANUAL
& CATALOG
Please take a moment to verify that the item was not damaged
in transit. Carefully unpack the box and check if everything is
included and in due condition. If there is any problem, please
contact us right away by email support@MediCrystal.com or
phone (800) 362-2088, so that we can resolve the issue as fast
as possible.
When you receive the box with your mat, if it is too cold or
too hot or wet outside, please, keep the mat inside for an hour
to adjust to room temperature before connecting to the power
socket.
The set Includes:
MediCrystal Mat
TM
Controller with terminal and plug wires for the
MediCrystal Mat
TM
Waterproof but FIR and Ions Permeable High Absorption
Protector for the MediCrystal Mat
TM
Bag for storage and carrying the MediCrystal Mat
TM
Owner’s Guide for the MediCrystal Mat
TM
UNPACKING AND PREPARING
WHAT IS IN THE BOX
SET UP MEDICRYSTAL MAT
TM
FOR OPERATION
Start by connecting the controller’s attachment (1) to the
receptacle
(2) on the MediCrystal Mat
TM
.
NOTE: This step MUST be rst or the mat’s controller may not
work and simply remain OFF.
To Next Page
Need help?
General
