MEDICUS® Dual Hinge Driver
“Drive Like a Pro”
To set the standard hinge tension, you
must check the club's response. Hold
the club parallel to the ground directly
in front of you, using one hand. Align
the hinge mechanism so it can break
downward allowing the head to fall
freely. The hinge at either position
should not break or bend in this
position, but remain rigid. The hinge at
both positions should react (by
breaking) with a short and quick
upward movement of your wrist. If the
hinge fails to break, the tension is set
too tight and should be adjusted at
either hinge adjustment point.
To make the hinge more responsive or
more fluid, turn the setscrew with the
included wrench counter-clockwise.
To make the hinge less responsive or
less fluid, turn the setscrew clockwise
to increase the tension.
12
To Next Page
Loading...