UK / NORTHERN IRELAND HELPLINE 0871 3761 020
REPUBLIC OF IRELAND HELPLINE 1-800-992 508
2
• The slits and openings in the hard disk are for air circulation. Do not cover these
openings, as this could lead to overheating.
• For additional safety, we recommend using power connection through a
power surge protection unit in order to protect your equipment from power
surges and lightning strikes.
• The voltages and interfaces used in the equipment are in line with the low
voltage protection guidelines set out in EN60950. Connections to other
equipment may only be made using similar interfaces with low voltage
protection in accordance with EN 60950.
• Please use our Service Center if you have any technical problems with your
hard disk. If repairs are needed, please use exclusively our authorised service
partners.
• In the first hours of operation, new devices may emit a typical, unavoidable
but completely harmless smell, which will decline increasingly in the course of
time.
We recommend you to ventilate the room regularly, in order to counteract the
formation of the smell.
Electromagnetic compatibility/Conformity
This device fulfils the requirements of electromagnetic compatibility and electrical
safety of the following:
EN 55022
Information technology equipment - Radio disturbance
characteristics - Limits and methods of measurement
EN 55024
Information technology equipment - Immunity characteristics -
Limits and methods of measurement
EN 61000-3-2
Electromagnetic compatibility (EMC) - Limits for harmonic
current emissions (equipment input current up to and
including 16 A per phase)
EN 61000-3-3
Electromagnetic compatibility (EMC) - Limitation of voltage
changes, voltage fluctuations and flicker in public low-voltage
supply systems, for equipment with rated current <= 16 A per
phase and not subject to conditional connection
EN 60950
Safety of information technology equipment
• Make sure that it is located at least one meter away from sources of high
frequency and magnetic disturbance (TVs, speakers, mobile telephones, etc.) in
order to avoid operational problems and data loss.
To Next Page
Loading...
