To Next PageTo Next PageWhat to do if my Medion MD 11850 Fryer food is not cooked?
If your food isn't cooking properly, it might be due to a few reasons. Make sure you are not overfilling the frying basket; fill it only up to 75%. Also, check that the cooking temperature isn't too low, increase the cooking temperature using the appropriate button. Finally, ensure the cooking time is sufficient; extend it if necessary by pressing the button twice.
Why is my food not evenly cooked in the Medion MD 11850 Fryer?
Uneven cooking can occur if the pieces of food are too close together. Many foods need to be shaken or turned several times during the cooking time. It is also important to fill the frying basket with small pieces of food, as smaller pieces cook more evenly.
Why does white smoke come out of my Medion Fryer?
White smoke may appear due to a couple of reasons. First, if the food you are cooking is very fatty, the fat can drip onto the base of the fryer pan during preparation, causing a higher temperature than usual. This does not impair the appliance or the cooking result. Second, the fryer pan may still contain oil or fat residue from a previous cooking process. To resolve this, clean the fryer pan and the frying insert after each use.
Why are my fresh chips not crisp in my Medion MD 11850 Fryer?
If your fresh chips aren't getting crisp, it could be due to the potatoes being too moist. The crispiness depends on the water and starch content of the potato variety used, as well as the amount of oil. Make sure to dry the potatoes carefully and cover them with about 1 tablespoon of cooking oil. Also, consider cutting the potatoes into smaller pieces.
Why are my fresh chips not evenly fried in my Medion MD 11850 Fryer?
Unevenly fried fresh chips could be because they haven't been soaked sufficiently. Place the chips in cold water for around 30 minutes to remove the starch, and then dry them using kitchen paper before adding them to the basket. Also, the variety of potato may be unsuitable.
What to do if my Medion MD 11850 Fryer appliance switched off automatically and shows error message F4?
The appliance may have switched off automatically due to the overheating protection being triggered, meaning the heating temperature exceeded 300°C. After the cooling phase, switch off the appliance and unplug the mains plug. Allow it to cool for another 10–20 minutes before using it again. If the overheating protection is triggered again, contact the service department.
Why won't my Medion MD 11850 Fryer close?
If your appliance won't close, it's likely because the frying basket is too full. Only fill the frying basket up to 75%.
Explains warning symbols used in the manual to convey hazards.
Guides on the first use and setup of the appliance, including placement and initial checks.
Covers various hazards like choking, electric shock, fire, burns, health, and damage risks.
Provides instructions on how to clean the appliance safely and effectively.
Explains how to use preset automatic cooking programs for different foods.
Guides on manually adjusting cooking time and temperature settings for custom recipes.
Details special programmes like preheating and keeping food warm.
Offers suggested cooking times and temperatures for various foods.
Covers interrupting/ending programmes and setting delayed start times.
General
