14
GB
3 Operating / 4 Miscellaneous
Upper back massage
3.3
Back
massage
1.
2.
3.
4.
Turn the adjustable feet anticlockwise until you can feel resistance. You
can now hang the unit over the back of a chair. A chair with a high back,
such as an office chair, is best suited to this purpose.
" "
Once you have completed the massage/heat treatment, press the
Power switch to switch off the appliance completely and
unplug the appliance from the wall outlet after use.
Plug the unit into the mains, making sure that the lead is not stretched.
The control switches are operated in the same way as described in the
instructions for foot massage.
You can use this method primarily for treating hardened muscles and
soothing tenseness in the neck and upper back region.
G
G
G
G
6
Lower back massage
1.
2.
3.
4.
Place the massager vertically on the seat of a chair, such that the unit
is leaning against and supported by the back of the chair.
Sit down on the chair, resting your back against the unit for treating
tenseness and hardened muscles in the lower back region.
G
G
Plug the unit into the mains, making sure that the lead is not stretched.
The control switches are operated in the same way as described in the
instructions for foot massage.
" "
Once you have completed the massage/heat treatment, press the
Power switch to switch off the appliance completely and
unplug the appliance from the wall outlet after use.
G
G
6
4 Miscellaneous
In general, you can allow approximately 10 to 15 minutes operation for
each massage session, one to two times a day. Make sure the appliance
is cooled down completely before using it again! G
3.4
Duration of
massage
treatment
4.1
Cleaning and
maintenance
Before cleaning the appliance, make sure that the appliance is switched
off and the power supply is disconnected. Allow the unit to cool down.
Clean the massager with a slightly damp sponge only. Never use brushes,
aggressive cleaning agents, petrol, thinners or alcohol. Rub the unit dry
with a clean dry cloth.
Never immerse the appliance in water to clean it and ensure water cannot
get into the appliance.
Wait until the device is completely dry before using it again.
Undo any kinks in the cable.
Take care to roll up the mains lead to avoid damaging it.
You should ideally store the device in its original packaging and keep it in
a clean, dry place.
G
G
G
G
G
G
G
•
•
•
•
•
•
•
To Next Page
Loading...
Need help?
General
