EN
35
CLEANING THE AIR FILTER
The air inlet lter should be removed and
blown clean with compressed air every 50
working hours. The lter element should
be replaced at least once every year if the
compressor is used in a clean environment,
and more often if used in dusty conditions.
REPLACING AND TOPPING UP THE OIL
Check the oil level every week and top up when
necessary. The oil in the compressor should be
replaced every 50 working hours. Synthetic oil
is preferable because it can withstand more
extreme temperatures in comparison with
mineral oil.
1. Undo the drain plug/sight glass (12) on
the oil pan and allow the oil to run out
into a suitable container before screwing
it back on.
2. Fill new oil through the oil ller hole until
the oil level reaches the marking in the
sight glass.
TROUBLESHOOTING
See next page.
To Next Page
Loading...