Meec tools 021743 - Page 57

EN
57
TESTING THE INSTALLATION
1. Set the maximum cutting height (60 mm)
when using the mower for the rst time.
2. Place the robot lawn mower inside the
mowing area and start it.
3. Watch the mower to see how it moves
and whether it operates correctly within
the perimeter wire.
4. Cancel mowing mode and check that
the mower returns along the perimeter
wire to the charging station. If the robot
lawn mower returns to the charging
station and docks without any problem,
the installation has been completed
successfully.
FIG. 15
FIG. 16
OPERATION
QUICK GUIDE (DISPLAY INTERFACE)
1. Time setting
2. Password setting
3. Power switch
4. Start/increase value
5. Go to charging station/reduce value
6. Conrm
7. Battery charge level
8. WiFi
9. Bluetooth
FIG. 17
Once the perimeter wire has been installed
in accordance with the instructions, the robot
lawn mower can be started.
1. Hold down the power switch until the
robot lawn mower turns on. The default
PIN code 0000 should be entered the rst
time a new robot lawn mower is used.
2. Press OK four times when the digit 0 is
ashing. (The PIN code can be changed
by the user.
NOTE:
The robot lawn mower will automatically
turn o if it does not receive any input within
30 seconds of being turned on.
If an incorrect PIN code is entered 10 times, a
warning sound is emitted and the robot lawn
mower turns o.
3. Press START and then OK to start mowing.
4. Press HOME and then OK to stop mowing
and to send the mower back to the
charging station.
The robot lawn mower will continue to cut the
lawn until the battery level is low, at which
point it will return to the charging station. The
robot lawn mower will automatically resume
mowing once the battery is fully recharged, or
will remain in the charging station until it is
next scheduled to start mowing.
FIG. 18
CHANGING THE PIN CODE
1. Hold down the START and HOME buttons
simultaneously for 3 seconds. The icon
for the password setting and the text PIN
1 will then ash to prompt you to enter
the old PIN code. After PIN 1 has been
displayed, the rst digit position ashes.
2. Select a digit by clicking up or down with
the START and HOME buttons respectively,
and press OK to conrm when the correct
digit is displayed. The next digit position
will then start to ash.
3. Repeat until all of the old PIN code has
been entered. When the old PIN code has
been correctly entered, PIN 2 will ash
and the rst digit will ash again. The new
PIN code can now be set.
4. Set the new PIN code following the
procedure above for the old code. When
the new PIN code has been correctly
set and starts to apply, the word IDLE is
displayed.