Meec tools 027415 - Error Code E3; Error Code E4; Error Code E5; Error Code E6

EN
55
E3 Blocked rotor. 1. Turn o the robot lawn mower.
2. Turn the mower upside down and inspect
for foreign objects that may be preventing the
rotor from turning.
3. Remove any obstacles.
4. Turn the robot lawn mower right side up,
move it to where the grass is short or adjust
the cutting height.
5. Press the power switch. Then press START
and OK.
E4 Obstruction sensor not reset. 1. Turn o the robot lawn mower.
2. Move the robot lawn mower to an area
where there are no obstacles.
3. Remove the oating cover and check that
its cylindrical magnets can move freely –
remove any obstructing objects – and replace
the cover.
4. Press the power switch. Then press START
and OK.
E5 The mower has been lifted o
the ground.
1. Turn o the robot lawn mower.
2. Move the robot lawn mower to an area
where there are no obstacles.
3. Press the power switch. Then press START
and OK.
4. If the error code is still displayed, turn o
the mower and turn it upside down. Inspect
for foreign objects that may be preventing the
front wheels axel from moving freely.
5. Remove any obstructions, turn the mower
upright and press the power switch. Then
press START and OK.
E6 Rollover sensor has been
triggered.
Turn the mower upright. Then press START
and OK.
E7 Tilt sensor has been triggered. 1. Turn o the robot lawn mower.
2. Move the mower to a at, horizontal
surface.
3. Press the power switch. Then press START
and OK.