Meec tools Multi Series - Page 44

EN
44
Assembly and replacing the tool’s accessories.
WARNING: Use only supplied or accessories specied by the manufacturer. Tool accessories can
be very sharp and can be in use become very hot - risk of personal injury. Wear safety gloves when
handling tool accessories and bits.
1. Place the tool on a stable surface, for example a work bench.
2. Align the tool accessory on the drive and press it into place until it locks.
3. Check that the tool accessory is properly positioned on the drive.
Switching On/O
1. Press the power switch to start the tool.
2. Release the power switch to stop the tool.
3. The tool features a variable speed. Press the power button longer to increase the speed,
release slightly to reduce the speed.
Use
1. Hold the tool rmly and put the right socket on the anvil. Fit the socket on the nut and hold
the tool frimly pressed against the nut, so that the socket does not slip. Press the power
switch to start screwing.
2. When the nut does not initially resist the tightening the impact wrench works like a normal
screwdriver. When the nut starts to become tight and resist the percussion function comes
into play automatically.
3. The tightening torque varies according to a wide range of dierent factors. For this reason,
check the torque with a torque wrench after tightening.
4. The nal torque achieved after a few seconds of tightenning varies according to the type
of nut, dimension and combination of materials. It therefore takes a little practice and
experience to judge the correct tightening time for a specic torque.
Charging the battery
The battery must be charged before using for the rst time. At this rst-time charging, the battery
should be fully charged. Otherwise, the battery will not reach its full capacity.
IMPORTANT: Only use the supplied charger to charge the battery.
1. Connect the battery to the charger and then connect the charger to the mains supply.
Charging takes place automatically.
2. Unplug the charger from the mains supply before removing the battery from the charger.