30
www.mega-motion.com Rascal
VI. COMFORT ADJUSTMENTS
TILLER ANGLE ADJUSTMENT
WARNING! Remove the key from the key
switch before adjusting the tiller or the
seat. Never attempt to adjust the tiller or
the seat while the Travel Scooter is in
motion.
Your Travel Scooter is equipped with an adjustable
pivoting tiller.
1. While supporting the tiller, turn the tiller
adjustment knob counterclockwise to loosen the
tiller. See figure 13.
2. Move the tiller to a comfortable position.
3. Turn the tiller adjustment knob clockwise to secure the
tiller in position.
NOTE: In order to fully lower the tiller, you must first
remove the seat and battery pack. Remove the seat by
pulling it straight up and off of the Travel Scooter.
SEAT ROTATION ADJUSTMENT
The seat rotation lever, located on the right side of the seat
base, secures the seat into several positions.
1. Pull up on the seat rotation lever to disengage the seat.
2. Rotate the seat to the desired position.
3. Release the lever to secure the seat into place.
ARMREST WIDTH ADJUSTMENT
The armrest width can be adjusted inward or outward.
1. Loosen the armrest adjustment knobs. See figure 14.
2. Use the attached ring to pull and remove the
detent pins.
3. Slide the armrests in or out to the desired width.
4. Align the adjustment holes on the seat frame and
armrest, then reinsert the detent pins.
5. Tighten the armrest adjustment knobs.
NOTE: Pivot the armrests upward to aid in getting onto
and off of your Travel Scooter.
SEAT HEIGHT ADJUSTMENT
The seat can be repositioned to different heights. See
figure 15.
1. Remove the seat from your Travel Scooter.
2. Disconnect the battery harness and remove the battery
pack.
3. Use the attached ring to pull and remove the detent pin
from the lower seat post.
4. Raise or lower the upper seat post to the desired seat
height.
Figure 13. Tiller Adjustment Knob
Figure 14. Seat Adjustments
DETENT PIN
ARMREST
ADJUSTMENT
KNOB
SEAT ROTATION
LEVER
UPPER SEAT POST
LOWER SEAT POST
Figure 15. Seat Height Adjustment
DETENT PIN