NOTES: Always be careful while soldering as high temperatures may result in
burns and damage to tissues. When heated for the first time the soldering
iron can emit some smoke as a result of tip and heater initial operation. This
STORAGE:
is not a sign of failure and can continue for around 10 minutes.
The soldering iron can only be stored in a locked room, away from children
and animals. Storage conditions should exclude the possibility of any
TIP REPLACMENT:
mechanical damage or weather impact.
MANUFACTURER:
PROFIX Co. Ltd.,
34, Marywilska St.,
03-228 Warsaw, POLAND.
ENVIRONMENTAL ISSUES:
The symbol nearby denotes that old equipment must never
be disposed together with other wastes (with the penalty of a
fine). Hazardous components of electronic equipment may
ź
adversely affect the natural environment and human health.
Each household may contribute to recovery and reuse (recycling) of old
machinery and equipment. Both in Poland and Europe a system for
recovery of used equipment either exists or is being developed. The
system obliges all organizations that sell such equipment to collect back
the used machinery and appliances. Moreover, general purpose
collecting points for such equipment are also available.
ź The list of service centers authorized to provide maintenance and
repairs in your country is provided in the warranty card.
NOTE: Tip (1) replacement can be carried out only when the plug (5) of the
power cord (4) is disconnected from the power socket and the tool is cold.
The soldering iron tip is subject to wear and requires replacement after a
certain time of use. To replace the tip undo the fixing screw (2) that
attaches it to the soldering iron and remove the old tip (see Fig. E, page 1).
Then, insert a new tip and fix it to the soldering iron by securely
tightening the fixing screw (see Fig. F, page 1).
CLEANING AND SERVICING:
NOTE: Always disconnect the soldering iron from the power supply.
Do not grind the soldering iron tips as they are covered with a
protective layer of solder (working part) and nickel (remaining part).
Grinding the tip will result in a loss of soldering properties and its
premature corrosion.
ź To clean the tip use a special sponge after damping it and cooling
down the tip or better, a tip cleaner that provides more efficient
cleaning and does not require reducing the tip temperature.
5
This instruction manual is protected by copyright. Copying it without the written consent of PROFIX Co. Ltd. is prohibited.
To Next Page
Loading...