8
Troubleshooting
PROBLEM CAUSE RECOMMENDATION
No power to radio control 1. Power switch is 1. Move switch to the “on”
transmitter or charger. in the “off” position.
position.
2. Batteries are 2. Make sure batteries are
incorrectly installed correctly.
installed.
3. Batteries are 3. Replace the batteries with
exhausted. new alkaline batteries.
No blinking red light when 1. Charge nozzle is 1. Double check the
charging. not properly connection.
plugged into the
charge port on the
HeliChopper.
2. Power switch on 2. Set switch to “on”
charger is in the position.
“off” position.
3. Batteries are 3. Replace all 8
exhausted. D-Size Batteries.
Chopper is not under control. 1. Radio control 1. Slide the switch to the
transmitter is not “on” position.
turned on.
2. Transmitter 2. Full
To Next Page
Loading...
