Meggitt ENDEVCO 4830A User Manual

DOCUMENT SUBJECT TO U.S. EXPORT CONTROLS, COMPLIANCE APPROVIAL REQUIRED PRIOR TO DISTRIBUTION
IM4830, Page 16
8.8.4 Re-adjust the frequency to 15.60 Hz. Verify the following display: m/s = 1.0000 (For rev D4
firmware verify that the display reads mm/s = 1000.0.
.
9.0 TROUBBLE SHOOTING GUIDE
a) Corrupted Display: If the display is corrupted (Due to low battery or transient power glitches). The
problem can generally be corrected by doing a “Memory Reset” as described in item 4. If the
problem persists, the unit is most likely defective.
10.0 TECNICAL SUPPORT
For technical assistance, contact the applications engineering department at Meggitt Sensing
Systems or your local representative or international distributor.
Questions
If you have any questions regarding the use of this or any Endevco product, please contact Endevco
Application Engineering at 1-800-982-6732 in North America, or your local sales representative.

Meggitt ENDEVCO 4830A Specifications

General

Brand	Meggitt
Model	ENDEVCO 4830A
Category	Measuring Instruments
Language	English