To Next PageTo Next Page
Need help?Do you have a question about the Meguiar’s G220 and is the answer not in the manual?
Defines DANGER, WARNING, and CAUTION terms related to potential hazards and injuries.
Read all instructions to prevent electric shock, fire, and serious injury.
Proper disposal and recycling of electric power tools to prevent pollution.
Use as a paint polisher for vehicles; not for sanding or grinding.
Keep work area clean, well-lit, and away from children or bystanders.
Match plugs to outlets; avoid adapters with earthed tools to reduce shock risk.
Ensure voltage matches tool (G110 for 110V, G220/G220EU for 220-240V).
Avoid contact with grounded surfaces to minimize electric shock risk.
Keep tools dry; do not abuse cords or use damaged cords.
Use appropriate, heavy-gauge extension cords for outdoor use to prevent overheating.
Stay alert and aware; do not operate when tired or under the influence.
Always wear eye protection and other safety equipment as needed.
Use the correct power tool for the application for optimal performance and safety.
Perform routine maintenance; repair damaged tools promptly before use.
Store idle tools out of reach of children and untrained users.
Use the tool and accessories according to instructions and intended purpose.
Have the power tool serviced by qualified personnel using identical replacement parts.
Hold by insulated surfaces; maintain firm grip with both hands.
Use rated accessories; operate only with all guards securely in place.
Limit use due to vibration; use gloves and take frequent rest periods.
Always wear proper hearing protection conforming to ANSI S12.6 during use.
Be aware of dust hazards; use approved masks and work in ventilated areas.
Ensure switch is OFF before connecting; slide switch forward to start, rearward to stop.
Adjust speed using thumbwheel (1-6); positions 3-5 optimal for operation.
Attach handle by sliding around body and securing with provided screws.
Disconnect power, use wrench to engage spindle, and rotate plate counterclockwise to remove.
Clean air passages with compressed air; wipe plastic parts with a damp cloth.
Check plug contact, fuses, or circuit breakers if the tool does not start.
General| Voltage | 120V |
|---|---|
| Orbit Size | 8 mm |
| Warranty | 1 year |
| Type | Dual Action Polisher |
| Power Source | Electric |
