To Next PageTo Next Page
Need help?Do you have a question about the MEI Cashflow SC66 and is the answer not in the manual?
General| Brand | MEI |
|---|---|
| Model | Cashflow SC66 |
| Category | Cash Counter |
| Language | English |
Details the SC66 model number structure, including flash unit and prom unit variants.
Explains the format of the serial number, including week, location, and production number.
Lists and briefly describes various features of the SC66 bill acceptor, covering hardware and operational aspects.
Identifies the three main components: Acceptor Module, Chassis, and Cashbox.
Describes the two types of bill entry guides available for the SC66.
Details the standby, acceptance, and peak power consumption, along with input voltage.
Provides step-by-step instructions for installing the chassis, including mounting holes and screw depth.
Explains how to insert and remove the acceptor module using the release lever.
Details the process of installing a bill entry guide, including harness connection and alignment.
Guides on inserting the cashbox into the chassis, ensuring proper seating and flush rear.
Explains how to remove the cashbox, both when installed and not installed in the machine.
Covers the installation of one or two security locks on the cashbox, including supported formats and rotation.
Details how to connect the Portable Programming Module (PPM) to the SC66 unit via USB.
Outlines the steps for downloading software using the PPM, including LED indicators and status codes.
Explains how to replace the programmed PROM chip in the acceptor module for software updates.
Provides pinout details for the 12-pin connector for RS232 and Opto Isolated EBDS versions.
Guides on how to fill out and use the configuration coupon for setting up the bill acceptor.
Details the procedure for cleaning the acceptor module, including precautions and cleaning agents.
States that the SC66 does not require user calibration and must be done by trained technicians.
Explains the color-coded diagnostic LEDs, their status, and necessary actions for troubleshooting.
Identifies the three main parts and explains the purpose of USB and 8-pin connectors.
Explains how software is updated in Flash and PROM units using PPM or chip replacement.
Defines the PPM and outlines its process for downloading software into SC66 Flash units.
Lists and explains MMI diagnostic error codes, their status, and required technician actions.
Explains how to distinguish between Flash and PROM SC66 units based on model number.
Compares various SC66 model numbers and explains differences between MEI EBDS and IGT Netplex interfaces.
Clarifies that field calibration is not permitted; only approved service centers can perform it.
Provides cleaning instructions, frequency, and states the operating voltage range for the SC66.
Confirms no dip switches; configuration via coupon. Explains wire purpose for cassette detection.
Details how to clear a bill jam and discusses swapping like-model acceptors.
Lists MEI service center locations and provides contact numbers for technical assistance.
