Green LED Codes
Coin Accepted
R
t
Coin Discrimination LED Codes
1 x Blink Inserted coin was accepted
2 x Blinks
Inserted coin was rejected – unknown
(not recognised by discriminator)
3 x Blinks
Coin rejected (Inhibited by machine or
changegiver program settings)
Amber LED Codes
The amber LED allows you to pinpoint a fault that may have occurred on one of
the modules of the changegiver. These types of fault can be rectified at the
machine and can be for example caused by; a coin jam, dirt built up or the
cassette has been removed etc.
Amber
Flashes
Changegiver Maintenance LED Codes
1 x Discriminator error
2 x Accept gate error
3 x
Separator module top level sensor
Tube cassette error
4 x Dispenser module error
3. Service Mode Options
Press Button
Sequence
Description / (Action)
Float coin tubes / (Insert coins then press button)
Clear credit accumulated – (Not MDB)
Inhibit a coin / (Insert a coin, press reject lever and then
press )
Enable a coin / (Insert a coin then press button)
Teach vend price / (Insert coins to the value of the price
and then press the price line button on the machine to
set it)
(When finished press the button)
Note: After teaching a price the changer is automatically
set into price holding mode.
[This feature is only available on Executive products]
Set to ‘Prices Held in VMC’
‘D’ button must be pressed within 6 seconds of the ‘C’
button.
Warning: This will clear all previously set prices.
[This feature is only available on Executive products]
Token Teach (channel 32) / (Insert 32 tokens through
the discriminator. After the 32
nd
token is inserted the
EC6000 assignes it as a ‘VEND’ token.
Press the button at any time to Cancel token teach
A
A A
B
B
C
D
C D
To Previous Page
Loading...
Need help?
General
