PBS V5.1 User’s Manual
12) If power adapter is damaged, please contact the manufacturer for replacement or
purchase the adapter which must be in conformity with the standard IEC 60601-1.
Using any non-compliant adapter may be dangerous.
13) PBSV5.1 Palm bladder scanner comply the relevant requirements of IEC60601-1-2
standard electromagnetic compatibility.
14) The user needs to install and use the device according to electromagnetic compatibility
information provided by the accompanying documents.
15) Portable and mobile RF communication devices may affect the performance of PBSV5.1
Palm bladder scanner. Please avoid these strong electromagnetic interference such as
mobile phones and microwave ovens, etc.
16) Guidance and manufacturer’s declaration stated in the appendix.
Warning:
1) Please read the instructions in Appendix C carefully when using the battery.
2) The maintenance service must be carried out by professional technicians. Users are not
allowed to disassemble the device. Or it may increase the maintenance difficulty and
cost, and even cause potential safety hazard.
3) Only trained doctors or authorized people by the medical institutions can use the PBS
V5.1. The users must fully study the User’s manual and understand all the instructions
before operating it. It will make the device abnormal or the practice result incorrect if
it is not followed by the instructions during the operation. To obtain the latest vision of
the User’s manual, please contact the distributor in your region.
4) The ultrasound is safe in the low acoustic power condition. Its safety has not yet been
fully confirmed in case of high acoustic power and long-time ultrasonic irradiation.
Please choose the lowest acoustic power and the shortest time to use.
5) In general situation, the heat of probe will not bring any uncomfortable feeling on
patients. However, if the environment temperature is too high (e.g. in summer), or the
probe is continuous used for a long time, the surface temperature of probe acoustic
window might increase(when the environment temperature is 40 ℃, the highest
surface temperature is less than 45 ℃), which might make the patients uncomfortable.
So per-scan will not be suggested to use for a long time while using the device,
To Next Page