Index
Page
1 Introduction and general instructions ................................................................... 4
1.1 Safe keeping of instructions ................................................................................. 5
1.2 Authorisation for service technicians of our service partners ............................... 5
1.3 Designation of installation type ............................................................................. 5
2 Explanation of the safety symbols used ............................................................... 6
3 General description and use for the purpose intended....................................... 7
3.1 General description .............................................................................................. 7
3.2 Determined use .................................................................................................... 7
4 EC-/EU-Declaration of Conformity ......................................................................... 7
5 Technical conditions ............................................................................................... 8
6 General safety rules ................................................................................................ 8
6.1 Operator’s duty of care ......................................................................................... 8
6.2 Basic safety measures ......................................................................................... 9
6.2.1 Basic safety measures for standard operation .............................................. 9
6.2.2 Basic safety measure for maintenance ....................................................... 10
6.2.3 Working on the electric fittings ..................................................................... 10
6.2.4 Before setting in operation - after maintenance and repair works .............. 11
6.2.5 Observe the environment protecting regulations......................................... 11
6.3 Notes - tray on-set section ................................................................................. 11
7 Assembly instructions (for a partially completed machine) ............................. 12
8 Delivery, transport, installation and assembly ................................................... 12
8.1 Delivery ............................................................................................................... 12
8.2 Transport ............................................................................................................ 13
8.3 Installation and assembly ................................................................................... 13
9 Special types of danger ........................................................................................ 14
9.1 Accident protection at tray-onset area................................................................ 14
9.2 Accident protection at the curve guiding rollers ................................................. 15
9.3 Accident protection in the curves ....................................................................... 15
10 Product description ............................................................................................... 16
10.1 Construction ....................................................................................................... 16
10.2 Check function of safety fittings .......................................................................... 16
10.3 Control panel ...................................................................................................... 17
10.4 Setting in operation............................................................................................. 17
10.5 Operation ............................................................................................................ 18
10.6 Switching on/off the round belt transport system ............................................... 18
10.7 Jam switch option ............................................................................................... 19
10.8 Transport stop key .............................................................................................. 20
10.9 230V / 400V socket ............................................................................................ 20
10.10 Position and level indicator ................................................................................. 20
10.11 Connection to BTA machines ............................................................................. 20
10.12 Folding conveyor table ....................................................................................... 21
To Next Page
Loading...
