MEISTER CRAFT MPS 710 E-P - Operating Instructions and Safety Hints; Scope of Delivery; Technical Information; Components Overview

42
1 – Scope of delivery
•Jig saw
•2 setting keys
• Parallel stop
•3 jig saw blades
•Vacuum adapter
• Operating Instructions
• Guarantee
2 – Technical information
Technical data
Power supply 230 V~/50 Hz
Nominal consumption 710 W
Stroke rate when
idling n
0
: 500–3000 min
-1
Stroke 18 mm
Angled cuts 2 x 0–45°
Connection cable ca. 250 cm
Weight 2,7 kg
Technical changes reserved.
Noise emission/vibration
L
PA
: 92,7 dB(A), L
WA
: 105,7 dB(A).
Hand/arm vibrations a
w
: 4,95 m/s
2
.
3 – Components
1 On/Off switch
2 Default stroke rate
3 Handle
4 Oscillation
5 Connection cable
6 Cutting guard
7 Connection for vacuum
8Cutting angle adjustment system
9 Guide roller
10 Saw shoe
11 Attachment device
12 Parallel stop
13 Vacuum adapter
14 Adjustment key
15 Jig saw blades
Operating instructions & safety hints
To prevent injury, always read the operating instructions before use and
pass them on to any future owners of the tool. Keep with the tool.
GB
Page
1 – Scope of delivery 42
2 – Technical information 42
3 – Components 42
4 – Application 43
5 – General safety
instructions 43
6 – Safety instructions
relating specifically to
the equipment 45
Page
7 – Installation and setting 45
8 – Operation 46
9 – Mode of operation 46
10 – Maintenance and
environmental
protection 47
11 – Service instructions 47
Contents
MCP-5453310-Bedien-0409.qxd 09.04.2009 10:57 Uhr Seite 42