How to improve slow connection on MEL M2-iLAN Scanner?
To address a slow connection with your MEL Scanner: * Ensure your network card supports 100 MBit. * Try using a different PC. * Implement an Ethernet switch. * Avoid using hubs.
Why is there a delay in the scan profile of my MEL M2-iLAN Scanner?
A delay in the scan profile of your MEL Scanner may be due to a slow connection or PC, or interference from Anti-Virus software. To resolve this: * Use a faster PC with a CPU clock of 800 MHz minimum. * Utilize a 100MBit network. * Use M2D-iVision for display.
What to do if I can't flash my MEL M2-iLAN with new firmware?
If you are unable to flash your MEL Scanner with new firmware, consider the following: * Check the RS-232 monitor prompt. * If the RS-232 monitor prompt doesn't work, check the RS-232 cabling. * Ensure you started with the batch-file. * Verify the firmware file is correctly set in the batch file. * Check for any error messages. * Confirm you are using the correct binary file.
What to do if Eth-Link and 100Mbit are lit but there is no connection on MEL Scanner?
If the Eth-Link and 100Mbit indicators are lit, but there is no connection with your MEL Scanner, try these steps: * Check the network settings. * Check the cable connection. * Reset the switches and restart the PC.
Why does my MEL M2-iLAN Scanner say it cannot load the firmware file when flashing over the network?
If you receive a 'cannot load firmware file' message when flashing your MEL Scanner over the network: * Ensure the scanner has been set to programming mode by powering down, setting the programming mode switch, and then powering up again while holding the Prog switch for a second. * Make sure you have the correct firmware file.
How to fix no LAN connection to my MEL M2-iLAN Scanner?
To troubleshoot a missing LAN connection to your MEL Scanner, try the following: * Check the network cable and try another cable. * Use an Ethernet switch. * Test with another PC. * Verify network card settings, using an x-link cable for a direct connection. * Check the RS-232 prompt when powering up the scanner. * Ensure the head is properly connected and the laser and LEDs are lit or blinking. * Confirm the IP address is available. * Power down the scanner to see if another device is using the IP address. * Try using M2D-iVision.exe. * Ping the IP address using the command prompt (cmd: ping xxx.xxx.xxx.xxx). A successful ping should occur when the scanner is powered on and no other device answers when it is off. * Review the PC's network settings to confirm the net...
To Next Page
General