Melchioni MINERVA 2 - Installation; LPG Cylinder Assembly

exceed 1.2m.
• Makesurehoseisnotkinked.Makesurethatwhenconnectedhosedoesnottouch
anywarmsurfaces.
• It’snecessarytochangetheexibletubewhenthenationalconditionsrequireit.
• OnlyregulatorcomplieswithEN 16129canbe used;.Always usealow-pressure
regulator to connect the gas cylinder to the stove. This regulator for I3+(28-30/37)
musttohaveexclusivelyaxedcalibrationnormalizedat37mbarforPropaneand
30mbarforButane.ForI3B/P(30),theregulatorshouldhaveaxedcalibration
normalized at 30mbar.
• Tostoretheproductalwaysindryandslightlymoistplaces,awayfromtheatmo-
spheric agents or factors that could damage the stove itself.
• Reparaitonmustbeperformedonlybyqualiedpersonnelintheservicecenters
authorized by the manufacturer or impoter.
• Avoidtoblocktheventurisofburners.Checkwhethertheventurisofburnersare
blocked before using the appliances.
• Thediametersofcookingvesselswhichcanbeusedare120mm~200mm.
• Parts sealed by the manufacturer or his agent must not be altered by the users.
• Anymodicationoftheappliancemaybedangerous.
INSTALLATION
• Place the stove on a horizontal surface respecting the instructions indicated in the
chapter of Safety Instruction .
• Checkthatthegaspipethatyouwanttouseisinaccordancewiththerulesinforce
inyourcountryandithasalreadyassembledwiththepressurereducerwiththecha-
racteristics described in the chapter of Safety Instruction and in the technical data
table.
• Insert into the gas pipe a full mesh metal clamp suitable for LPG gas pipes .
• To insert the gas pipe in the stove gas’s connector on the back of the stove and push
it until the pipe is inserted up to the connector for at least 2cm .
• Tighten the metal clamp in order to seal safely the rubber hose to the stove connec-
tor.
LPG cylinder assembly
• Beforeassemblingthecylinder,turntheburnervalve’sknobsclockwiseuntilthem
reach the closed position.
• Place the gas cylinder in a stable and dry surface
• Connect the pressure regulator already assembled to the gas pipe to the LPG cylinder
makingsureyouhavecorrectlyinsertedthesealgasketsuppliedwiththecylinder.
• AlwaysusethenewgasketssuppliedtogetherwiththeLPGcyclinder.