16
STEAM IRONING
INSTRUCTIONS FOR USE
How to ll the boiler tank before use
DO NOT UNSCREW THE BOILER CAP UNLESS YOU ARE SURE THAT THE APPLIANCE HAS BEEN
UNPLUGGED FROM THE OUTLET AND THAT THE PRESSURE INSIDE HAS BEEN RELEASED.
Do not unscrew the boiler cap unless you are sure that the appliance
has been unplugged from the outlet .
When water in boiler is lack,” Lack warter” pilot lamp lights up,
Unscrew safety cap. Pour 1.2 litres of normal tap water into the tank by means of funnel. Screw the
safety cap on tightly.
How to start the appliance
1b. Set the iron temperature to the “COTTON-LINEN” steam position, by turning the
knob. All types of fabric can be ironed at this temperature.
2b. Wait for the indicator light of steam go on and the steam button light go off.
Push button (10) on the iron to release bursts of steam form the holes on the soleplate.
Regulate the steam capacity by turning the steam regulater(14).
Use the “Steam Holding System” can keep the steam burst without the nger
pressure.
When the pressure gauge pointer pointed to green position, you can set the Steam
adjustment.
Check that the voltage indicated on the data plate corresponds with
that of the local network before connecting the appliance to the supply mains.
The appliance uses ordinary tap water.
If the water is very hard (hardness higher than 27 degrees French). We suggest using
distilled or demineralized water.
Always remove the plug from the power socket before lling the boiler
Unscrew the cap and pour in about 1.2 litres of water.
After closing the cap. Connect the appliance to the power supply.
Press the boiler’s switch and wait for the water to start boiling (about 8 minutes). Next,
press switch to turn on the iron and then select the desired temperature by means of the
thermostat knob .
When the light goes off, the set temperature has been reached and the iron is ready for
use. It takes about 8minutes for the boiler to reach the optimum Ironing pressure.
When the appliance is ready for use the steam pilot lamp lights up.
When using the iron for the rst time, iron a plain cloth rst.
To obtain steam, press the steam button. It is no steam when you press the steam but-
ton. Release the steam button when steam is no longer required.
To Next Page
Loading...