Melges 14 - Step 10: Leading the Mainsheet

THE MELGES 14 : STEP 10
LEADING THE MAINSHEET
•
Start at the 57 mm carbo ratchet mounted
aft of the board box.
•
Lead the 7 mm black mainsheet line
through the ratchet in the opposite direction
of the arrows on the side of the block.
•
Go up through the mod boom 40 mm T2
block, aft through the sheet minder webbing,
aft through the 40 mm T2 block on the aft
end of the boom, down through the 29 mm
T2 block on the traveler bridle, (lead through
from stern to bow) then up to the loop
attached to the 40 mm T2 on the aft end of
the boom. Lead the line through the loop
from stern to bow, make sure you put the
line through the two ends of the loop, right
next to the zip tie. Then tie a figure 8 knot
in the end of the line.
MELGES.COM • MELGES14.COM