To Next PageTo Next Page
Need help?Do you have a question about the Melissa & Doug PARKING GARAGE and is the answer not in the manual?
General| Brand | Melissa & Doug |
|---|---|
| Model | PARKING GARAGE |
| Category | Indoor Furnishing |
| Language | English |
Lists the necessary tools, primarily a Phillips screwdriver, for assembling the parking garage.
Attach one connector (A) to the Base Ramp (2) using one small screw (B).
Attach the Base Ramp (2) to the Base (1) with a small bolt (F), not tightening completely.
Attach two lower pillars (D) to the base using two large bolts (C) from underneath.
Attach the Elevator (3) to the base using two large bolts (C) from underneath.
Slide the 1st Floor (4) into the bottom grooves on the Elevator and rest on the Lower Pillars.
Fasten the 1st Floor with two Upper Pillars (E) and secure the connector to the ramp.
Slide the 2nd Floor (5) into the elevator and allow it to rest on the pillars.
Fasten the 2nd Floor using two Upper Pillars (E), aligning and starting before tightening.
Slide the 3rd Floor (6) into the elevator as shown.
Fasten the 3rd Floor using two large bolts (C) through the floor and into the pillars.
Attach two connectors (A) using two small screws (B) to one of the Floor Ramps (7).
Place the Floor Ramp with connectors between the 2nd and 3rd Floors and attach with two small screws (B).
Attach the last two connectors (A) to another Floor Ramp (7) using two small screws (B).
Attach this Floor Ramp between the 1st and 2nd Floors using two small screws (B).
Fit the Attendant's Booth (8) to the base using 2 large screws (F).
