To Next PageTo Next PageWhat to do if the main burner cannot light on my Member's Mark TG2008214-MM-00 Grill?
If the main burner on your Member's Mark Grill won't light, try the following: * Check the LP cylinder fuel level. * Check to see if the grill will match light. The electrode or collector may need adjustment.
How to fix a Member's Mark TG2008214-MM-00 Grill burner that does not get hot enough?
If the burner on your Member's Mark Grill isn't getting hot enough, it's possible that the flow control device has been activated in the regulator. To resolve this, see the Regulator Resetting Procedure under Connecting LP Cylinder and Hose / Regulator to Grill.
Why is my Member's Mark TG2008214-MM-00 Grill too hot?
Your Member's Mark Grill might be too hot due to several reasons: Excess grease build-up may be causing grease fires, so cleaning the grill according to the Maintenance and Cleaning instructions is recommended. A damaged or faulty regulator could also be the culprit, in which case you should replace it with factory authorized parts. Also, make sure that you cook on a lower temperature setting.
What to do if there is a fire at the control knob of my Member's Mark TG2008214-MM-00 Grill?
If you notice a fire at the control knob of your Member's Mark Grill, it could be due to a few reasons. The gas connections may be loose, so perform a leak check and tighten all connections. Note that the burner holes may be obstructed; in this case, see the section on “Burner Cleaning” under Maintenance and Cleaning instructions.
General| Brand | Member's Mark |
|---|---|
| Model | TG2008214-MM-00 |
| Category | Grill |
| Language | English |
Pre-installation checks and requirements for LP gas cylinder connection.
Essential inspections to perform on the gas hose and appliance before each use.
Details the specific requirements for the LP gas cylinder, including type and safety features.
Step-by-step process for igniting the grill burners using the ignition button.
