EasyManua.ls Logo

Members Mark GR2150901-MM-00 - User Manual

Members Mark GR2150901-MM-00
39 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
1 of 39 20141119-Ver1
Gas & Kamado Combo Grill
Model Number: GR2150901-MM-00
Assembly and Operating Instructions
For Outdoor Use Only
This instruction manual contains important information necessary for the proper
assembly and safe use of this product. Read and follow all warnings and instructions
before assembling and using this product. Failure to follow these instructions and
warnings could result in damage to the product or injury to the user. Keep this
instruction manual for future reference.
Should you encounter any problem,
CALL US FIRST.
DO NOT return product to the retail store!!
WE CAN HELP.
For assistance, contact customer service at customerservice@rankam.com
or at (888) 837-1380, Mon to Fri, 8:00am – 5:00pm Pacific Standard time

Table of Contents

Questions and Answers

  • E
    Elizabeth WilliamsonAug 1, 2025
    What to do if my Members Mark GR2150901-MM-00 Grill burner does not get hot enough?
    • J
      Jonathan ReeseAug 1, 2025
      If your Members Mark Grill burner isn't getting hot enough, it could be due to the flow control device being activated in the regulator. To reset it, turn off all burners and close the LP gas cylinder valve. Disconnect the regulator from the LP gas cylinder and wait one minute. Reconnect the regulator to the LP gas cylinder and slowly open the LP gas cylinder valve until it is fully open. Light all burners and observe the temperature. Also, the burners may be blocked by spiders and insects.
  • M
    Michael BradleyAug 4, 2025
    Why won't my Members Mark GR2150901-MM-00 Grill main burner light?
    • L
      Linda CollinsAug 5, 2025
      There are several reasons why the main burner on your Members Mark Grill might not light. First, check the LP cylinder fuel level. Second, check to see if the grill will match light. The electrode or collector may need adjustment. Third, the burner tube may be improperly seated into the burner valve, so reinstall the burners. Fourth, the burner may be obstructed. Also, the cylinder valve may be closed or the regulator is not properly seated on cylinder valve.
  • T
    Timothy RobertsAug 9, 2025
    Why does the flame blow out on “LOW” on my Members Mark GR2150901-MM-00?
    • K
      Kathryn HollandAug 9, 2025
      If the flame blows out on the 'LOW' setting on your Members Mark Grill, it could be because the burner may be obstructed, or the burner tube may be improperly seated into the burner valve, so reinstall the burners. The grill might not be sufficiently preheated.
  • G
    Gail ElliottAug 13, 2025
    Why won't the side burner and back burner light on my Members Mark GR2150901-MM-00?
    • M
      Michael MilesAug 13, 2025
      If the side burner and back burner on your Members Mark Grill won't light, check to see if debris is blocking the electrode. Also, the ignition electrode may be too close or too far away from the burner (less than 1/8” or more than 3/16”), so adjust the electrode position accordingly.
  • A
    Allison MorrisAug 17, 2025
    Why is there a yellow flame at the burner of my Members Mark Grill?
    • R
      Robert BirdAug 17, 2025
      A yellow flame at the burner of your Members Mark Grill could indicate that the burner may be obstructed. The grill might be in a windy location.
  • P
    penamargaretAug 21, 2025
    What to do if I see a fire at the control knob of my Members Mark Grill?
    • C
      Cindy WilliamsAug 21, 2025
      If you notice a fire at the control knob of your Members Mark Grill, it could be that the valve orifice is improperly seated into the burner tube, so reinstall the burners. Alternatively, gas connections may be loose, so perform a leak check and tighten all connections. It is also possible that burner holes may be obstructed.
  • O
    Oscar DanielAug 26, 2025
    Why does my Members Mark GR2150901-MM-00 take a long time to preheat?
    • T
      Tracy Perez IIAug 26, 2025
      Normal preheat to 500-600 °F, takes about 10-15 minutes. Cold weather and wind may effect your preheat time.

Summary

USE OF LP GAS CYLINDER AND INSTALLATION

LP GAS CYLINDER

Details specifications and requirements for LP gas cylinders.

INSTALLING GAS CYLINDER

CONNECTION PROCEDURES

TO DISCONNECT LP CYLINDER

PRODUCT DIAGRAM

COMPONENT LIST

Replacement Part List (I)

Replacement Part List (II)

ASSEMBLY PROCEDURES

LEAK TEST

LIGHTING INSTRUCTIONS

LIGHTING THE MAIN BURNER AND SIDE BURNER OF GRILL

LIGHTING THE BACK BURNER

USING MATCH HOLDER TO LIGHT MAIN BURNER, SIDE BURNER AND BACK ROTISSERIE BURNER

MAINTENANCE & CLEANING INSTRUCTIONS

GRILL BURNERS

BURNER CLEANING

AFTER-USE SAFETY

PROPER CARE & MAINTENANCE

TROUBLE SHOOTING

LIMITED WARRANTY

Members Mark GR2150901-MM-00 Specifications

General IconGeneral
BrandMember's Mark
ModelGR2150901-MM-00
TypeGas Grill
Fuel TypePropane
MaterialStainless Steel
Ignition TypeElectronic
Side BurnerYes
Rotisserie BurnerNo
Warranty1 year

Related product manuals