Need help?Do you have a question about the Memmert WNB 7 and is the answer not in the manual?
Instructions for safe handling and movement of the waterbath unit.
Details about stainless steel, electrical safety, and EMC compatibility.
Overview of the microprocessor-controlled heating and standard features.
Procedure for the first time the bath is powered on.
Specific steps for starting the waterbath operation.
Guidelines on using non-flammable liquids and proper filling procedures.
Description of the control panel buttons, displays, and indicator symbols.
Steps for powering the waterbath on and off.
Instructions on how to adjust temperature, delay, and hold time settings.
How to set the desired operating temperature and the boiling mode.
How to configure a delay before the bath starts heating.
How to set a duration for the bath to maintain the set temperature.
A step-by-step guide to setting up a temperature program.
How to observe the bath's status during delayed start, heating, and hold periods.
Details on the built-in safety device to prevent overheating.
How the bath protects itself if the liquid level becomes too low.
Information about the electronic relay that monitors and controls heating during faults.
Instructions for using gable and flat covers for optimal performance.
How to set up and use the optional automatic water level control system.
Instructions for connecting and using the optional cooling device.
Procedures for cleaning the tank and housing to ensure longevity.
A guide to identify and resolve common operational issues and error codes.
What happens to the bath's settings and operation during a power interruption.
Definitions of key terms used in the manual.
Formal declaration of the product's compliance with European directives.
Contact information for the manufacturer and support services.
Instructions for safe handling and movement of the waterbath unit.
Details about stainless steel, electrical safety, and EMC compatibility.
Overview of the microprocessor-controlled heating and standard features.
Procedure for the first time the bath is powered on.
Specific steps for starting the waterbath operation.
Guidelines on using non-flammable liquids and proper filling procedures.
Description of the control panel buttons, displays, and indicator symbols.
Steps for powering the waterbath on and off.
Instructions on how to adjust temperature, delay, and hold time settings.
How to set the desired operating temperature and the boiling mode.
How to configure a delay before the bath starts heating.
How to set a duration for the bath to maintain the set temperature.
A step-by-step guide to setting up a temperature program.
How to observe the bath's status during delayed start, heating, and hold periods.
Details on the built-in safety device to prevent overheating.
How the bath protects itself if the liquid level becomes too low.
Information about the electronic relay that monitors and controls heating during faults.
Instructions for using gable and flat covers for optimal performance.
How to set up and use the optional automatic water level control system.
Instructions for connecting and using the optional cooling device.
Procedures for cleaning the tank and housing to ensure longevity.
A guide to identify and resolve common operational issues and error codes.
What happens to the bath's settings and operation during a power interruption.
Definitions of key terms used in the manual.
Formal declaration of the product's compliance with European directives.
Contact information for the manufacturer and support services.
General| Model | WNB 7 |
|---|---|
| Category | Laboratory Equipment |
| Volume | 7 liters |
| Interior Material | Stainless steel |
| Voltage | 230 V |
| Frequency | 50/60 Hz |
| Power Supply | AC |
| Temperature Uniformity | ± 0.5 °C |
| Temperature Fluctuation | ± 0.3 °C |
| Control Type | Microprocessor PID-temperature controller with auto-diagnostic system |
To Next Page
