Need help?Do you have a question about the MEMMINGER-IRO MLT WESCO and is the answer not in the manual?
Precautions against electrostatic discharge damaging electronic components.
Only original MEMMINGER-IRO spare parts should be used for replacement.
The unit must be charged before first use or after a long period of non-use.
The MLT WESCO offers four selectable measuring modes: MACHINE SPEED, YARN LENGTH, YARN TENSION, YARN SPEED.
The YARN LENGTH mode can be set between 1 to 100 machine revolutions.
The YARN TENSION mode can be set to Normal, Average, or Peak values.
The MLT WESCO automatically switches off after 5 min of disuse or 15 min of measuring.
The maximum clearance between the magnet and revolution sensor must not exceed 5 mm.
Instructions for connecting the MLT WESCO to the revolution sensor.
The symbol 'C' is shown when the magnet passes the revolution sensor.
During measurement, the MLT WESCO must be held still and straight.
Measurement stops when the swivel arm release handle is released or no longer pressed.
Yarn length can be measured within the range of 1 to 100 machine revolutions.
The weight used for calibration must not swing during the process.
The calibration procedure may need to be repeated several times for exact results.
The battery provides approximately 50 hours of normal use.
Only a moist cloth should be used; no chemical cleaning agents are permitted.
Covers power supply, charger, battery type, duration, and charging time.
Details measurement units and ranges for machine speed, yarn length, tension, and speed.
Identifies MEMMINGER-IRO GmbH as the manufacturer.
Lists the harmonised standards the product conforms to.
Precautions against electrostatic discharge damaging electronic components.
Only original MEMMINGER-IRO spare parts should be used for replacement.
The unit must be charged before first use or after a long period of non-use.
The MLT WESCO offers four selectable measuring modes: MACHINE SPEED, YARN LENGTH, YARN TENSION, YARN SPEED.
The YARN LENGTH mode can be set between 1 to 100 machine revolutions.
The YARN TENSION mode can be set to Normal, Average, or Peak values.
The MLT WESCO automatically switches off after 5 min of disuse or 15 min of measuring.
The maximum clearance between the magnet and revolution sensor must not exceed 5 mm.
Instructions for connecting the MLT WESCO to the revolution sensor.
The symbol 'C' is shown when the magnet passes the revolution sensor.
During measurement, the MLT WESCO must be held still and straight.
Measurement stops when the swivel arm release handle is released or no longer pressed.
Yarn length can be measured within the range of 1 to 100 machine revolutions.
The weight used for calibration must not swing during the process.
The calibration procedure may need to be repeated several times for exact results.
The battery provides approximately 50 hours of normal use.
Only a moist cloth should be used; no chemical cleaning agents are permitted.
Covers power supply, charger, battery type, duration, and charging time.
Details measurement units and ranges for machine speed, yarn length, tension, and speed.
Identifies MEMMINGER-IRO GmbH as the manufacturer.
Lists the harmonised standards the product conforms to.
General| Brand | MEMMINGER-IRO |
|---|---|
| Model | MLT WESCO |
| Category | Measuring Instruments |
| Language | English |
To Next Page