4
OPERATION
Slide the AUTO/OFF/REV switch to
the AUTO position; the POWER
indicator will light.
1
Insert up to 5 pages of 20lb paper
into the shredder, and the unit will
automatically shred them.
2
Follow the instructions below to operate your new shredder.
After unpacking the shredder, place it securely on the supplied wastebasket.
Then, plug the unit into an AC outlet as described on page 1.
NOTES:
• If inserting small documents, insert them in the center of the shredder as
the sensor is located there.
• Do not attempt to insert more than 5 pages at a time, as it will shorten
the life of the shredder.
• The shredder will stop automatically if it is overheated by long and
continuous intermittent operation. Allow the shredder to rest for
approximately 20 minutes to cool down.
WASTEBASKET FULL INDICATOR:
When the wastebasket is full, the BIN FULL indicator will light on the cover.
Empty wastebasket in this case.
WASTEBASKET PROTECTION:
As a safety feature of this shredder, if the top unit separates from the
wastebasket, the shredder will not operate.
To Next Page
Loading...
Need help?
General