6
1) In Memory-Map on the 2800 tap the Menu button and then the Settings button and then select
Overlay > Save As from the menu. Give the file a name using the keyboard button and then tap
OK to save.
2) Connect your Adventurer 2800 to your PC with the supplied USB cable and tap the USB Mass
Storage button on the screen. The 2800 will now be seen by your PC as two removable drives.
3) In Memory-Map on your PC click Overlay > Import. In the Open window that appears choose the
Removable Drive that contains the SD card inside the unit. It can be easily identified as it will
contain a number of Memory-Map folders and a Userdata folder.
Double-click on the Userdata folder and then open the file you previously saved on your
Adventurer 2800. The overlay file will now be displayed on your PC.
Sending maps to the Adventurer 2800
Both existing Memory-Map V5 maps and Memory-Map Digital Map Shop maps can be sent to the
Adventurer 2800 and stored on the SD card.
To open maps on the GPS tap the Menu button and then the Settings button and then tap Map…
A list of maps will appear. If you have recently sent a map from your PC tap the Refresh button to
update the map list. To open a map tap once on the name and the map will be displayed.
Sending non Digital Map Shop maps
If you have existing Memory-Map V5 maps that are not Digital Map Shop maps then they can be
sent to your Adventurer 2800 in a number of ways. Please note that there is a limit of up to 400MB
per map so please make sure your maps are below this size when sending to the GPS.
Method 1 – Sending the whole map
If the map is under 400MB in size then you can send the whole map in one go by following the steps
below:
1) With the Adventurer 2800 powered on connect the GPS to your PC with the supplied USB cable
and tap the USB Mass Storage button on the screen. The 2800 will now be seen by your PC as
two removable drives.
To Next Page
Loading...
