EasyManua.ls Logo

Memphis DC12V - General Safety Precautions; Safe Device Operation Guidelines; Intended Use of the Cooler

Memphis DC12V
7 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
After sales support TEL: 1300 366 144
GENERAL SAFETY
Do not operate the device it is visibly damaged.
Do not damage the cooling system.
Do not place any electrical devices inside the cooler.
Ensure that the ventilation slots are not covered.
Keep to the following distances:
-A gap of at least 10cm at the rear.
-A gap of at least 5cm on either side.
The cooling device is not suitable for transporting caustic materials or materials containing
solvents.
Pull out the connection cable or disconnect the hose connection.
-Before cleaning and maintenance.
-After use.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or
OPERATING THE DEVICE SAFELY
Electronic devices are not toys.
This appliance is not intended for use by persons (including young children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
Danger of fatal injury:
Do not touch exposed cables with your bare hands. This is especially applies when operating the
device with an AC mains power supply.
Never immerse the device in water.
Protect the device against splashing water.
Protect the device against and the cable against heat and moisture.
Only use the device in well vented areas.
The device may give
a smell for a short time when it is operated.
Only operate the device from a single energy source.
Do not place the device near
or other heat sources (heater, direct sunlight, gas ovens).
Do not
the inner container with ice or
INTENDED USE
The cooler is suitable for cooling foods and drinks. The device is suitable for camping.
The cooler has been designed for operation with a 12V DC voltage source (eg. the cigarette lighter of a
vehicle) or alternatively for operation with a mains voltage of 220-240V AC.
The cooler can be operated independently a voltage supply with liquid gas (LPG).
IMPORTANT:
Place the cooler on a rm and level base. Check the horizontal position
with a spirit level if necessary.
Please note this cooler is an absorbtion cooler which is a silent operation.