Need help?Do you have a question about the Menabo ACONCAGUA and is the answer not in the manual?
General| Type | Roof box |
|---|---|
| Color | Black |
| Material | ABS |
| Opening | Dual side |
| Lock Type | Central locking system |
| Locking system | Central locking |
| Compatibility | All vehicles (check roof bar compatibility) |
Clean the vehicle's roof and the magnetic sheets before installation.
Determine installation position, ensure full magnetic contact, and parallel alignment.
Secure the carrier to the front of the roof using the safety strap.
Slide and fasten buckles to ensure the carrier is securely attached.
Place spacers at regular intervals along the strap to prevent roof contact.
Turn the key counter-clockwise to unlock and open the clamp.
Observe capacity, position skis with rear ends forward, and note max thickness.
Close the clamp to secure cargo and lock the carrier with the key.
Pull the hook upward to break the magnetic seal and remove the carrier.
Wash the carrier system and store it in its original box when not in use.
Install only on smooth roofs without sunroofs, T-tops, or other features.
Keep the roof surface clean to ensure magnetic adhesion.
Do not place stickers or protective sheets between the carrier and roof.
Be careful not to bump skis with the vehicle's rear hatch or trunk lid.
Do not leave carrier mounted in temperatures exceeding 30°C (86°F).
Never leave carrier mounted for longer than 36 hours at a time.
Do not exceed 130 km/h (80 mph) for skis, 100 km/h (62 mph) for snowboards.
Always remove the carrier before running the car through a car wash.
After driving, check that the carrier and cargo are still securely mounted.
To Next Page
