23
• Store the small parts and
packaging materials out of
the reach of children – risk
of suocation.
SYMBOLS
Read the instructions.
Approved in accordance
with the relevant standards/
directives.
Recycle discarded product
in accordance with local
regulations.
TECHNICAL DATA
Rated voltage 230 V
~
50 Hz
Energy class F
Temperature range 0–12°C
Size Ø 41 x 67 cm
Weight 13 kg
USE
NOTE:
Wait three minutes before restarting
the product if it has been switched o or
unplugged. The built-in compressor protector
prevents it from restarting straight away.
INTENDED USE
• The product is only intended for
household use. The product is not
intended for commercial use.
• The product is only intended to be
used to cool drinks and food. Use the
product only for its intended purpose.
The product must only be used for its
intended purpose and in accordance with
these instructions.
BEFORE USING FOR THE FIRST TIME
• Before using for the rst time, clean the
product with a cloth moistened with water
and a mild detergent, and wipe dry.
• The temperature in the fridge
compartment depends on the ambient
temperature, on the contents, and on
how often and for how long the lid is
opened. The time it takes to reach the set
temperature can therefore vary.
• The product must be placed on a level
surface. If the product has to be tilted, for
example when moving it, stand it upright
for 20 to 30 minutes before plugging in
the plug and starting it. If the product has
been on its side it must stand upright for
24 hours before plugging it in, otherwise
the product can be damaged and will not
work properly.
TEMPERATURE SETTING
• The temperature is set with the dial on
the product. The dial can be turned to the
o position (OFF) and has 8 temperature
settings.
• The lowest setting (position 1)
corresponds to approx. 12°C.
• The highest setting (position 8)
corresponds to approx. 0°C.
• Each step corresponds to approx. 1.5°C.
PROCEDURES FOR BEST COOLING
• The rst time the product is started it
should be run nonstop for 12–18 hours.
• The contents cool quicker if they are
placed at some distance from each other.
Do not overload the product.