141Multifunction steering wheel, multifunction display
Technical
data
Instruments
and controls
Operation Driving
Instrument
cluster display
Practical hints Car care Index
Press the è or ÿ button repeatedly until the
individual setting preliminary display (1) appears.
Press the j or k button until the setting menu
“SETTINGS” (2) is displayed.
Pressing the æ or ç button controls the selection
marker (3) in setting menu (2).
“INST. CLUSTER”, see page 142.
“LIGHTING”, see page 144.
“VEHICLE”, see page 147.
Pressing the è or ÿ button displays the next or
previous system.
Notes:
These settings may only be performed with the
electronic key in starter switch position 1 or 2.
To return menu “SETTINGS” (2) to its factory
setting:
• Call up the individual setting preliminary
display (1).
• Press the J button in the instrument cluster for
approximately 3 seconds. Display (4) will appear.
• Press the J Button once more. The menu
“SETTINGS” is reset to factory settings,
acknowledged by display (5).
The individual setting preliminary display (1) will
appear if you do not press the J button within
about 5 seconds. The setting menus will not be
reset.
Note:
For safety reasons, the individual setting “LAMP
CIRCUIT HEADLAMP” in menu cannot be reset while
driving, see page 144. If an attempt is made, the
message “LIGHTING” – “CANNOT BE COMPLETELY
RESET TO FACTORY SETTINGS WHILE DRIVING” will
be displayed.
J_OM_215.book Seite 141 Mittwoch, 30. Mai 2001 2:01 14
To Next Page
Loading...
Need help?
General
