280
Control systems
Instrument cluster control system
왘 Press % or $ to select the
“Rearview camera” function.
왘 Press #.
왘 Press # again if you would like to
change the current status.
The following settings are available:
Service menu
The “Service” menu is used for
앫 calling up messages
앫 checking tire inflation pressure elec-
tronically with the Advanced TPMS*
(standard on U.S. vehicles)
앫 activating Run Flat Indicator
(Canada only)
앫 calling up the maintenance service in-
dicator display
앫 check engine oil level*
Calling up vehicle malfunction, warning
and system status messages stored in
memory
Use the vehicle status message memory
menu to scan malfunction and warning
messages that may be stored in the sys-
tem. Such messages appear in the multi-
function display and are based on
conditions or system status the vehicle’s
system has recorded.
The vehicle status message memory menu
only appears if there are any messages
stored.
왘 Press ( or & to select the
“Service” menu.
“On when in
Reverse”
The Dynamic Rear View
Monitor automatically
switches on when reverse
gear is engaged.
“OFF” The Dynamic Rear View
Monitor is not switched on.
i
The menu overview can be found on
(
컄 page 266).
Warning! G
Malfunction and warning messages are only
indicated for certain systems and are inten-
tionally not very detailed. The malfunction
and warning messages are simply a remind-
er with respect to the operation of certain
systems and do not replace the owner’s
and/or driver’s responsibility to maintain
the vehicle’s operating safety by having all
required maintenance and safety checks
performed on the vehicle and by bringing
the vehicle to an authorized Mercedes-Benz
Center to address the malfunction and
warning messages (
컄 page 612).
컄컄
To Next Page
Loading...
Need help?
General
