Lumbar support
You can adjust the contour of the driver’s seat
lumbar support to help enhance support to
your spine.
X
Curvature position: Use button : to
move the curvature up and button = to
move it down.
X
Degree of curvature: Use button ; to
lessen the curvature and button ? to
increase it.
Rear seat head restraints
G
Warning!
For your protection, drive only with properly
positioned head restraints.
Adjust the head restraint in such a way that it
is as close to the head as possible and the
center of the head restraint supports the back
of the head at eye level. This will reduce the
potential for injury to the head and neck in the
event of an accident or similar situation.
With a rear seat occupied, make sure to move
the respective head restraint up from the
lowest non-use position and have the
occupant adjust the head restraint properly.
Do not drive the vehicle without the seat head
restraints installed when the rear seats are
occupied. Head restraints are intended to
help reduce injuries during an accident.
G
Warning!
Make sure the rear seat head restraints
engage when placing them upright manually.
Otherwise their protective function cannot be
ensured.
The back of the head will not be supported in
the event of a collision. That could cause
serious or even fatal injuries. Rear seat
occupants can be seriously injured or killed.
Rear seat head restraint height
adjustment
X
Raising: Pull head restraint : upward to
the desired position.
X
Lowering: Press release button ; and
push down on head restraint :.
Rear seat head restraint fore and aft
adjustment
84
Seats
Controls in detail
164_AKB; 7; 31, en-US
d2ureepe, Version: 2.11.8.1
2009-09-11T12:07:36+02:00 - Seite 84
To Next Page
Loading...
Need help?
General
