14
Have all damage repaired before continuing to operate the wallbox. Until then, take the wallbox out of operation as described
in section “Taking the product out of and back into operation” on page 9.
• The Mercedes-Benz Wallbox does not have a dedicated ON/OFF switch: If you want to take the wallbox out of operation,
you must always switch the upstream fuse(s) and the domestic RCCB to the 0 (OFF) position.
• The proper functioning of the external RCCB must be checked biannually to ensure it functions correctly during operation.
Cleaning and care
• The surface of the Mercedes-Benz Wallbox can be cleaned with a dry cloth.
• Do not use aggressive cleaning agents, waxes or solvents (such as cleaning fluid or paint thinner) because they can dull the
housing and the displays on the device.
• Do not use abrasive cleaning agents or sponges as these can scratch the surface of the housing cover.
DANGER!
The Mercedes-Benz Wallbox must under no circumstances be cleaned with a pressure cleaner or any similar device where
liquids or steam could enter the openings in the housing because of high pressure.
Trademarks
All trademarks mentioned in this manual including those that may be protected by third parties are, without restriction,
subject to the regulations of the respectively applicable trademark law and the property rights of the respective registered
owners.
All trademarks, trading names or company names marked here as such are or may be trademarks or registered trademarks of
their respective owners. All rights not explicitly granted here are reserved.
The absence of explicit identification of trademarks used in this manual must not lead to the conclusion that a name is free
from the rights of third parties.
Intellectual Property & Copyright
Copyright © 2017
Version 1.1, MB-UM-Wallbox-2017-03-06
All rights reserved.
Any information in this manual may be changed without prior notice and does not represent any obligation on the part of the
manufacturer.
Illustrations in this manual may show designs different from the delivered product and do not represent any obligation on the
part of the manufacturer.
The manufacturer does not take responsibility for any loss and/or damages that occur because of the data or possible misin-
formation contained in these instructions.
This manual, in its entirety or in parts, must not be reproduced, stored electronically or otherwise transmitted electronically,
electrically, mechanically, optically, chemically, by photocopy or as an audio recording without the written permission of the
manufacturer.
To Next Page
Loading...
Need help?
General
