persons or animals are in the area in which
you are maneuvering. You could otherwise
injure them.
i
Infrared light is not visible to the human
eye and therefore does not glare. Night
View Assist Plus can therefore remain
switched on even if there is oncoming
traffic.
:
Night View Assist Plus camera
Switching on Night View Assist Plus
Depending on your vehicle's date of
manufacture, the c or à symbol for
the "Automatic driving lights/daytime
running
lamps" position is located on the light
switch.
You can only activate Night View Assist Plus
if:
R
the
SmartKey is in position 2 in the ignition
lock.
R
it is dark.
R
the light switch is set to either c,
à or L.
R
reverse gear has not been engaged.
X
Make sure that COMAND is switched on.
X
Press button :.
The
Night View Assist Plus display appears
in the COMAND display.
:
Night View Assist Plus display
;
Pedestrian recognized
=
Framing
?
Symbol for active pedestrian recognition
You can read about how to adjust the
brightness of the COMAND display in the
COMAND operating instructions.
i
The infrared lamps switch on
automatically
from a speed of about 6 mph
(10 km/h). This means that you do not have
the full visual range while the vehicle is
stationary and cannot check whether Night
View Assist Plus is working.
Pedestrian recognition
G
WARNING
Pedestrian recognition may be impaired or
inoperative if:
R
pedestrians are partially or entirely
obscured by objects, e.g. parked vehicles.
R
the
silhouette of the pedestrian in the Night
View Assist Plus display is incomplete or
interrupted, e.g. by powerful light
reflections.
Driving systems
201
Driving and parking
Z
To Next Page
Loading...
Need help?
General
