On-board computer:
Service Tyres
#
Swipe downwards on Touch Control on the
left-hand side of the steering wheel.
The Run Flat Indicator activeRestart: press
Touch Control message is shown in the mul‐
tifunction display.
Restart the tyre pressure loss warning system in
the following situations:
R
The tyre pressure has changed.
R
The wheels or tyres have been changed or
newly fitted.
#
To begin restart, press Touch Control on the
left-hand side of the steering wheel.
The Tyre pressure now OK? message is
shown in the multifunction display.
#
Select Yes .
#
To confirm restart, press Touch Control on
the left-hand side of the steering wheel.
The Run Flat Indicator restarted message is
shown in the multifunction display.
After you have driven for a few minutes, the
tyre pressure loss warning system monitors
the set tyre pressures of all the tyres.
Be sure to also observe the following further
related subjects:
R
Notes on tyre pressure (→ page 402)
Wheel change
Notes on selecting, fitting and replacing
tyres
Mercedes-AMG vehicles: observe the notes in
the Supplement. Otherwise, you may fail to rec‐
ognise dangers.
You can ask for information regarding permitted
wheel/tyre combinations at a Mercedes-Benz
Service Centre.
&
WARNING Risk of accident due to incor‐
rect dimensions of wheels and tyres
If wheels and tyres of the wrong size are
used, the wheel brakes or wheel suspension
components may become damaged.
#
Always replace wheels and tyres with
those that fulfil the specifications of the
original part.
When replacing wheels, make sure to fit the
correct:
R
Designation
R
Type
When replacing tyres, make sure to fit the
correct:
R
Designation
R
Manufacturer
R
Type
&
WARNING Risk of injury through exceed‐
ing the specified tyre load-bearing capa‐
city or the permissible speed rating
Exceeding the specified tyre load-bearing
capacity or the permissible speed rating may
lead to tyre damage and to the tyres burst‐
ing.
Wheels and tyres
409
To Next Page
Loading...
Need help?
General
