If you modify component parts of these high-
voltage components or touch damaged com-
ponent parts, you may be electrocuted.
High voltage components may be damaged in
an accident, although the damage may not be
visible.
#
Never perform modications to compo-
nent parts of high-voltage components.
#
Never touch damaged component parts
of high-voltage components.
#
Never touch component parts of high-
voltage components aer an accident.
Vehicles with a 48 V on-board electrical system
contain high-voltage components. These compo-
nents are marked with a high-voltage label:
All work on high-voltage components must be car-
ried out at a qualied specialist workshop.
Notes on assembling the license plate on the
front license plate holder
*
NOTE Malfunctions and system failures
due to incorrect mounting of the license
plate on the front license plate holder
If the license plate is incorrectly mounted on
the front license plate holder, sensors, cam-
eras or driving and safety systems may mal-
function or fail.
Observe the following points when mounting
the license plate on the front license plate
holder:
#
Mount the license plate directly on the
license plate holder without advertising
media or other holders.
#
Mount the license plate so that it does
not protrude above or to the side of the
license plate adapter.
National information for components relevant to
radio regulation
Information on crossing national borders
You must observe the radio regulations for the
country in which you are currently operating your
vehicle.
USA: "Radio based devices of this vehicle comply
with Part 15 of the FCC Rules. Operation is sub-
ject to the following two conditions: 1) These devi-
General notes
29
To Next Page
Loading...
Need help?
General
